Course Outline

Servicing the Siemens Family Ultrasound S2000 (2.5 Day)


Ultrasound systems are found in most radiological/diagnostic imaging departments. They are typically exposed to a higher abuse level due to elevator openings, tight room entrances, limited patient access, and lack of space for maneuverability. This constant abuse will cause premature mechanical failure if not properly identified and corrected early. The trained service professional will be taught the skills necessary for mechanical, electromechanical, and electronic maintenance of the Ultrasound system. Each sub-system of the mechanical unit and the generator are thoroughly analyzed.


To attend this course, the service professional must have a good understanding of the principles of Ultrasound or 3 years equivalent experience.


At the conclusion of this course participants will be able to:

  • Understand theory of operation of the Siemens Ultrasound Family
  • Demonstrate the operations
  • Evaluate overall system performance
  • Troubleshoot mechanical and electronic problems on all components of the unit
  • Perform a complete and thorough preventive maintenance inspection on each unit
  • Follow circuit operations of system detail block diagrams
  • Identify signal flow and label system block diagrams
  • Understand image quality as it pertains to ultrasound
  • Identify probes and their uses
  • Perform networking and DICOM setup

Tuition: $4495

Course Length: 2.5 Days

CEU's Awarded: 4 CEU’s


  • Call RSTI for Info
Register Course Schedule   Course Outline  
Need parts?

RSTI eXchange is your multi-manufacturer, multi-modality solution for diagnostic imaging replacement parts.
Request Parts

Course Outline

Day 1
  • Introduction
    • System Features
    • Basic theory of operations
      • Switches/Controls
      • Terminology
    • Specifications
    • Software Navigation
  • Basic system/unit differences
    • Mechanical
      • Covers and Panels
    • Electronic
    • Documentation
  • Lab Activities
    • Basic operation
  • Modes of Operation
    • B-modes
    • M modes
    • Doppler (PW/CW) Modes
  • Lab Activities
    • Scanning session
  • Lab Activities
    • Disassembly, parts location and  identification and reassembly
  • Power supplies analysis
    • Theory
    • Block diagrams
  • Lab Activities
    • Power supply checks and test points
  • Diagnostic tools and menus
    • LEDs and test points
Day 2
  • DICOM and Networking
    • Conformance statement basics
    • Networking basics
    • DICOM basics
  • Lab Activities
    • Perform networking setup and verify operations
    • Perform DICOM setup and verify operations
  • PM procedures
  • QA procedures
  • Lab Activities
    • Perform a PM on each system
    • Perform a phantom QA for each system
Day 3
  • System troubleshooting
    • Mechanical
    • Electronic
  • Lab Activities
    • Mechanical troubleshooting
    • Electronic troubleshooting
  • Overall system review
  • Final exam
  • Course evaluation
  • To register for a course, fill out the information below or download our registration form.

    For information on travel expenses and hotel accommodations please see our full coverage package information.
  • Course Registration

  • Personal Information

  • Contact Information

  • This field is for validation purposes and should be left unchanged.

Please fill out the form below and we will contact you regarding replacement parts.

  • This field is for validation purposes and should be left unchanged.
Send Me Course Updates
  • This field is for validation purposes and should be left unchanged.